FANUC: 18/180i-A 1 SLOT STAND ALONE BASIC UNIT

Part Number: A02B-0266-B501
Product Series: A02B-0266

FEATURES:
The Fanuc 18/180i A series control units are divided into two types: the LCD-mounted type and stand-alone type. LCD-mounted type control units have a built-in display. Stand-alone type control units have a separate display unit.

The control unit is equipped with a fan motor. Air is fed into the bottom of the unit and output from the fan motor mounted on the top of the unit.

FANUC thus recommends that the battery be replaced periodically, once a year, regardless of whether a battery alarm is issued. The following two kinds of batteries can be used.

• Lithium battery built into the CNC control unit.

• Two alkaline dry cells (size D) in the external battery case.

HIGHLIGHTS.

The control unit is equipped with a fan motor.

Air is fed into the bottom of the unit and output from the fan motor

mounted on the top of the unit.

Also, adequate service access space is required in front of and at the top

of the unit so that printed circuit boards and the fan motor can be replaced

easily if necessary.

There is a spare connector located at the far end (at middle height) on the

right side of the control unit. This connector is used for controller testing

and other purposes. Therefore, connector is required..

All the stand–alone type control units of the Series

180i are designed to connect an intelligent

terminal by inserting an HSSB interface board into a mini

slot. These control units are the same as those of the Series

18i.