|
Yes, but more as a problem to the entire system including
the drive. Here is a list of Do’s and Don’ts:
DO:
- Determine power requirements using both HP and torque to
choose the proper diameter core for the application.
- Use the highest possible rpm to transmit power, thus
lowering the torque load on the shaft.
- Operate the shaft in the largest possible radius, avoiding
sharp bends or kinks.
- Install the shaft properly, letting the casing be straight
for several inches beyond the ferrule, clamping it into position whenever
possible and avoiding excessive lengths.
- Always use a means of shaft alignment; misalignment causes
heat and mechanical breakdown of the coupling.
DON'T:
- Bend a core into a radius smaller than recommended, even
during shipment (if you are an OEM.)
- Overlook direction of rotation in choosing
a core.
- Use the flexible shaft to support anything - it was not designed to
be a handhold or a footrest or a support!
- Ignore routine maintenance. Speak
with your motor or coupling distributor for more information.
|